Logo

P0290 Engine Code Repair

Meaning of P0290 engine trouble code is a kind of powertrain trouble code and when the check engine light comes P0290 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

P0290 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P0290 code is occuring now you should check P0290 repair processes.
Now don't ask yourself; What should you do with P0290 code ?
The solution is here :

P0290 Possible Solution:

P0290 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

P0290 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

0
Intake Valve Control Solenoid Circuit Low

2
Fuel Rail/System Pressure - Too High

9
Ignition/Distributor Engine Speed Input Circuit Malfunction

0
Reverse Input Circuit

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P0290 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P0290 OBD-II Trouble Code Code P0290 is triggered when the Engine Control Module ( P0290 code.

Main reason For P0290 Code

The reason of P0290 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

P0290 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.